We use cookies to improve your website experience. Learn about our cookie policy.

Accept

Skip to Content
Flexco - Partners in Productivity
Main Content

FXC™ Steel Cord Belt Fastening System

  • FXC Splice
  • FXC Hero Image
  • FXC Field Install
  • FXC In Field Australia
  • FXC With Cover

FXC™ STEEL CORD BELT FASTENING Applications

Emergency Splice

The FXC™ can be installed quickly when there is a splice failure or significant belt damage so the operation can get back up and running until a vulcanized splice is installed. This installation takes approximately five hours with four workers on a 72 in. (1800mm) wide belt. 

Belt Pull

The FXC™ can be used to pull a belt onto the conveyor system quickly and efficiently. Belt pull kits use the same components as an emergency splice but quantities may be reduced depending on belt pull tension requirements. This installation takes approximately three hours with four workers on a 72 in. (1800mm) wide belt.

  • Products
  • Specifications
  • Instructions
  • Sales Support
Apply FiltersClose

Product Type

clear
Installation Tools(1)
Refine Results
Please wait while we gather your results.
Steel Cord Belt "ST" Rating Cord Diameter Range Cord Pitch Range Minimum Belt Thickness Splice Thickness Hinge Pin Diameter
Up to ST2500 2.5mm to 7.7mm 11mm to 23mm Emergency Splice: Restrictions* Belt Pull: No Restrictions** 25.4mm or 31.4mm*** 13mm or 19mm

Splices must be covered with a self-leveling liquid urethane to prevent sifting when running material. Cover material available from Flexco upon request.             
                    
*Emergency Splice Note: For belts thinner than the splice, grade the cover material for a smooth transition from belt to splice. Reduce cleaner tension/drop the cleaner in cases where the belt thickness exceeds the splice thickness in Column E.                    
**Belt Pull Note: This splice does not require covering and should not be conveying material. Therefore belt thickness is not a restriction.                    
***Cord pitch greater than 20mm or cord diameter greater than 6.8mm requires 31.4mm splice thickness.                     
Contact Flexco for details.                    

410 Stainless was selected due to its durability and strength, as well as its corrosion resistance and formability.

Please wait while we gather your results.
Please wait while we gather your results.